TRIMS & FASTENINGS / BUYING ANSWER
Specifying hook-and-loop placement.
How should hook-and-loop closure areas be described?
details to the table.
Read the answer.
Review the requirements.
Discuss your project.
THE BUYING ANSWER
Start with a clear definition.
Mark the two mating areas, overlap direction and finished dimensions on a drawing. Review the fastened and open sample. Specify which edges remain exposed so the design can be assessed as a complete closure rather than two isolated strips.
The decision behind the detail.
A larger fastening area can change stiffness and the visible overlap. Compare operation and appearance together.
PREPARE ONLY WHAT IS RELEVANT
Three details to bring.
- Mating areas
- Mark the position and dimensions of both sides.
- Overlap
- Describe the intended closed arrangement.
- Exposed edges
- Identify the areas visible when open and fastened.
Check together
- Check orientation of the mating materials.
- Review nearby trim and label interference.
- Record the closure arrangement used for fit measurements.
READY TO DISCUSS THIS DETAIL?
Take it into your project.
Go straight to an enquiry, or add a note first. Every field here is optional.
Add a working note (optional)
Leave anything undecided blank. These notes do not approve a sample or order.
Preparing your local note…